Audiopipe XV-BXP-SUB

 If you want to get the most out of your car audio system, a quality digital bass processor is a must.  This will allow you make the adjustments needed to help get the best optimization possible.  The sweep will let you pick certain frequencies you want the bass circuit to maximize.  Having a lower sweep, the bass will be centered around lower frequencies and a higher sweep will be centered around higher frequenices.  This processor will also alow you to change the width.  The Wide will allow you to control how wide of a frequency range it will effect.  If you have the width low the bass will be centered around a smaller frequency range, and if you increase the width, you increase the frequency range.

The bass processor is installed before any crossovers or signal processors usually after the dash unit. This digital bass processor also comes with a bass knob, so you can also adjust it easily.  

Specifications:

• Maximum Input Level: 15V RMS
• Maximum Output Level: 13.5V Peak
• Frequency Response: 0Hz-100kHz±1dB
• Total Harmonic Distortion: 0.003%
• Signal to Noise Ratio: -130dB
• Balanced Input Noise Rejection: >60dB
• Input Impedance: 10 KOhm
• Output Impedance: 150 Ohms
• Power Supply: High Headroom PWM
• Power Draw: 150mA
• Includes Bass Knob

Audiopipe XV-BXP-SUB

 If you want to get the most out of your car audio system, a quality digital bass processor is a must.  This will allow you make the adjustments needed to help get the best optimization possible.  The sweep will let you pick certain frequencies you want the bass circuit to maximize.  Having a lower sweep, the bass will be centered around lower frequencies and a higher sweep will be centered around higher frequenices.  This processor will also alow you to change the width.  The Wide will allow you to control how wide of a frequency range it will effect.  If you have the width low the bass will be centered around a smaller frequency range, and if you increase the width, you increase the frequency range.

The bass processor is installed before any crossovers or signal processors usually after the dash unit. This digital bass processor also comes with a bass knob, so you can also adjust it easily.  

Specifications:

• Maximum Input Level: 15V RMS
• Maximum Output Level: 13.5V Peak
• Frequency Response: 0Hz-100kHz±1dB
• Total Harmonic Distortion: 0.003%
• Signal to Noise Ratio: -130dB
• Balanced Input Noise Rejection: >60dB
• Input Impedance: 10 KOhm
• Output Impedance: 150 Ohms
• Power Supply: High Headroom PWM
• Power Draw: 150mA
• Includes Bass Knob